What happens to your PEC file
Every needle point lands in the same place in the JEF file as in the PEC file, and Hoopbench reads the new file back to prove it before you save it. The details below are what actually changes between these two formats.
| Stitch positions | Identical, to 0.1 mm |
|---|---|
| Colour stops | Same number, same order |
| Thread colours | Matched to the Janome chart |
| Size and density | Unchanged |
Thread colours
PEC and JEF each use their own fixed thread list, so each thread is matched to the nearest in the Janome chart. Neighbouring stops stay different, and the names will change. Match by eye against your own spools if the exact shade matters.
Long moves
JEF moves at most 12.7 mm per record, against 204.7 mm in PEC. Longer moves are split into a chain of jumps, and a stitch longer than 12.7 mm becomes jumps followed by one stitch. Every needle point stays in the same place.
Trims
JEF has no trim record. Trims are dropped from the file and the machine cuts when a jump is long enough, usually about 3 mm or more.
Before you stitch
- Open the .pec file above and watch it sew, so you know the file is sound and in the order you expect.
- Choose your hoop under Hoop fit. The check uses the design's real size, not the file's header.
- Download the .jef file, and stitch a test piece on matching fabric and stabiliser.
Converting doesn't resize a design or change its density. If a design needs to be much bigger or smaller, use digitising software, as stretching stitches without recalculating them can leave gaps or heavy spots.
About PEC
PEC is the machine section of a PES file on its own. It holds stitches, a list of slots in the 64 colour Brother chart, and small black and white thumbnails for the machine screen.
Exact thread colours. Only the Brother chart slot is stored, and the design name is cut to 8 characters.
About JEF
JEF is the Janome format. Its header records the hoop it expects, the stitch count, and a colour for each stop as a slot in a fixed Janome thread list.
The JEF file is for Janome machines, and Elna machines that read JEF. Any Janome or Elna machine that reads JEF.
If you need a cut after a very short jump, a JEF machine may not make it. Inspect the jumps before you run it.