What happens to your HUS file
Every needle point lands in the same place in the JEF file as in the HUS file, and Hoopbench reads the new file back to prove it before you save it. The details below are what actually changes between these two formats.
| Stitch positions | Identical, to 0.1 mm |
|---|---|
| Colour stops | Same number, same order |
| Thread colours | Matched to the Janome chart |
| Size and density | Unchanged |
Thread colours
HUS and JEF each use their own fixed thread list, so each thread is matched to the nearest in the Janome chart. Neighbouring stops stay different, and the names will change. Match by eye against your own spools if the exact shade matters.
Long moves
Both formats move at most 12.7 mm per record, so nothing needs splitting.
Trims
JEF has no trim record. Trims are dropped from the file and the machine cuts when a jump is long enough, usually about 3 mm or more.
Before you stitch
- Open the .hus file above and watch it sew, so you know the file is sound and in the order you expect.
- Choose your hoop under Hoop fit. The check uses the design's real size, not the file's header.
- Download the .jef file, and stitch a test piece on matching fabric and stabiliser.
Converting doesn't resize a design or change its density. If a design needs to be much bigger or smaller, use digitising software, as stretching stitches without recalculating them can leave gaps or heavy spots.
About HUS
HUS is an older Husqvarna Viking format. It stores commands, x moves and y moves as three separate compressed streams, with colours as slots in a list of 29 threads.
Exact colours, since only the 29 thread list is available.
About JEF
JEF is the Janome format. Its header records the hoop it expects, the stitch count, and a colour for each stop as a slot in a fixed Janome thread list.
The JEF file is for Janome machines, and Elna machines that read JEF. Any Janome or Elna machine that reads JEF.
If you need a cut after a very short jump, a JEF machine may not make it. Inspect the jumps before you run it.